Dual Stereo to Mono Converter
The RB-SM2 is a dual version of the RB-SM1, consisting of two independent converters which will produce two fully buffered and balanced mono line outputs from two stereo inputs.
All connections are on the rear panel. The XLR-3 inputs are electronically balanced with an impedance of 20kΩ bridging. These can be wired unbalanced to accept an output from domestic equipment.
The XLR-3 line outputs are electronically balanced with an output impedance of <50Ω. The outputs can be wired unbalanced by grounding the non-phase signal, allowing you to feed both balanced and unbalanced equipment.
Output gain adjustment using pre-set potentiometers for both converters allows a normalised mono output from domestic stereo equipment. The potentiometers are accessible through the rear panel.
|Maximum Input Level:||+28dBu|
|Maximum Output Level:||+28dBu|
|Input Impedance:||>20kΩ balanced bridging|
|Output Impedance:||<50Ω balanced|
|Frequency Response:||20Hz to 20kHz ±0.1dB (600Ω load, ref 1kHz)|
|Gain Range:||Adjust -8dB to +18dB gain, ref. 0dB input on L and R|
|Common Mode Rejection:||>66dB typically|
|Distortion:||0.01% THD @ 1kHz, ref +8dBu output|
|Noise:||-100dB, unity gain, ref +8dBu output|
|Inputs:||4 x XLR 3 pin female (Balanced, can be unbalanced)|
|Outputs:||2 x XLR 3 pin male (Balanced, can be unbalanced)|
|Mains Input:||Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max|
|Fuse Rating:||Anti-surge fuse 100mA 20 x 5mm (230VAC) Anti-surge fuse 250mA 20 x 5mm (115VAC)|
|RB-SM2:||Dual stereo to mono converter|
|Dimensions (Raw):||28cm (W) x 10.8cm (D) x 4.2cm (H) (1U) 11” (W) x 4.3” (D) x 1.7” (H) (1U)|
|Dimensions (Boxed):||36cm (W) x 20.5cm (D) x 6cm (H) 14.2” (W) x 8” (D) x 2.4” (H)|
|Weight:||Nett: 1.05kg Gross: 1.50kg Nett: 2.3lbs Gross: 3.3lbs|
TRU Price Guarantee
(Subject to conditions)