TRANSMITTERS
UHF Digital output Power:
30 W, 50 W, 80 W and 130 W rms @ MER 40 dB typ.
UHF Analogue output power:
50 W, 100 W, 220 W p.s.
VHF Digital output Power:
up to 100 W rms @ MER 38 dB typ.
VHF Analogue output power:
220 W p.s.
Frequency agility:
UHF Band IV and V or VHF Band III
Frequency resolution:
1 Hz
Pre-Correction:
Adaptive
RF Connector:
N(f), 50 Ohm
MODULATOR
DVB-T/-H/-T2
Standard:
EN300744, EN302304, EN302755, TS101191, TS102773 (T2-MI), TS102034
Inputs:
4x ASI BNC (f), 75 Ohm or 2x ASI BNC (f), 75 Ohm and 2x RJ45 TS oIP 10/100/1000
Switch seamless between ASI inputs.
Hierarchical and not hierarchical (DVB-T)
FFT:
1K (DVB-T2), 2K, 4K, 8K, 8K ext. (DVB-T2), 16K & 16K ext. (DVB-T2), 32K & 32K ext. (DVB-T2)
Code Rate:
All modalities available according to the standard
Block Short or Normal (DVB-T2)
DVB-T: Reed-Solomon (204, 188)
DVB-T2: BCH, LDPC
Guard Interval:
1/32, 1/16, 1/8, 1/4, 19/256 (DVB-T2), 19/128 (DVB-T2), 1/128 (DVB-T2)
Constellation:
QPSK, 16QAM, 64QAM, 256QAM (DVB-T2). Rotated and non rotated (DVB-T2)
MISO Processing:
Supported
ISDB-Tb
Standard:
ABNT NBR 15601, ABNT NBR 15603
Inputs:
4x ASI TS/BTS BNC (f), 75 Ohm or
2x ASI TS/BTS BNC (f), 75 Ohm and 2x RJ45 TS/BTS oIP 10/100/1000
FFT:
Mode 1 (2K), Mode 2 (4K), Mode 3 (8K)
Code rate:
1/2, 2/3, 3/4, 5/6, 7/8
Guard Interval:
1/4, 1/8, 1/16, 1/32
Hierarchical Modulation:
Up to 3 layers
Constellation:
QPSK, 16QAM, 64QAM
Time interleaver:
Fully supported
Partial reception:
Supported
DAB/DAB+/T-DMB
Standard:
EN 300401, ETS 300 799
Inputs:
4x ETI (NI[G703], NA5376[G704] or NA5592[G704]) BNC (f), 75 Ohm
Transmission Modes:
Mode I, II, III, IV
(Automatically detected from the ETI stream, or user selectable)
Operation:
MFN or SFN operations
ATSC
Standard:
A/53, A/110
Inputs:
4x ASI / SMPTE-310M BNC (f), 75 Ohm or
2x ASI / SMPTE-310M BNC (f), 75 Ohm and 2x RJ45 TS oIP 10/100/1000
Modulation:
8-VSB
Input bit rate:
19.39 Mbit/s
Bandwidth:
6 MHz
Max processing delay:
Up to 1 second (programmable)
Analogue
Standard:
B, G, D, K, M, N, I
Inputs:
Video BNC (f), 75 Ohm, audio Tini-QG “Mini XLR”, 6 Pin (m), 600 Ohm
Color system:
PAL, NTSC
SATELLITE RECEIVER (Option)
Standard:
ETSI EN 300 421 (QPSK) (DVB-S)
ETSI EN 302 307 (QPSK, 8PSK, 16APSK) (DVB-S2)
ETSI EN 50083-9 (ASI)
ETSI EN 50221 (Common Interface)
DVB-S2:
VCM, CCM, Multi Stream and Single Stream, Normal & Short FEC frames
Symbol Rate:
1 – 45 Msym/s (DVB-S)
2 – 45 Msym/s (DVB-S2)
Constellation:
QPSK, 8PSK, 16APSK
FEC:
Automatic, all modalities available according to the standard
Block Short or Normal
DVB-S: Reed-Solomon (204, 188)
DVB-S2: BCH, LDPC
Roll–Off:
0.2, 0.25, 0.35
Input connector:
F (f), 75 Ohm
Frequency:
L–band 930÷2250 MHz
LNB control voltage:
Off, +13/18 Vdc, 22 kHz, 0.25 A (overload protection)
RF input level:
40 ÷ 100 db/μV (with attenuator)
Output connector:
BNC (f), 75 Ohm
Modality:
188 bytes
Max input bit rate:
80 Mbps (CAM limit: 72 Mbps)
CAM interface:
PCMCIA DVB-CI Common Interface
CA mode (Conditional Access):
Multicrypt, Simulcrypt
CAS support:
Mediaguard, Viaccess, Irdeto, Conax, BISS with Professional multiprogram
CAM (descrambling of up to 24 Elementary Streams) Betacrypt, Cryptoworks, Nagravision with standard consumer CAM
(descrambling of up to 4 services)
REPEATER/GAP FILLER
RF Input
Signal type:
One DTV channel (DVB-T/H/T2, ISDB-T/Tb, ATSC)
Frequency range:
170 ÷ 862 MHz (agile tuning)
Sensitivity:
-75 ÷ -15 dBm
Selectivity :
> 60 dB ± 4.2 MHz
NF (Pi=-50 dBm):
< 6 dB
Conversion type:
Direct Base Band Conversion (Zero IF)
Return losses:
> 15 dB
Connector:
N (f), 50 Ohm
Echo Canceller
Cancellation level:
40 dB, typical
Cancellation window:
20 μs
Selective cancellation window:
1.6 μs (time shift from 2 to 820 μs)
Doppler cancellation:
yes
Maximum echo/signal ratio:
+15 dB (over the main signal), typical
Total delay:
< 10 μs
Echo Canceller + RF Echo canceller option
Cancellation level:
70 dB, typical (over the main signal)
Maximum echo/signal ratio:
> +40 dB (over the main signal), typical
Maximum echo level at input:
-10 dBm
Max. delay compensation:
200 μs (approx. 40 m. of cable)
GPS / GLONASS (Option)
Input connector:
N (f), 50 Ohm
Input/Monitor output 10 MHz:
BNC (f), 75 Ohm
Input/Monitor output PPS:
BNC (f), 75 Ohm
Phase noise:
-140 dBc/Hz @ 10 kHz
-150 dBc/Hz @ 100 kHz
Stability:
1e-12 / 24 H with disciplined OCXO
Hold-over stability:
5 μs after 5 hours (optional 1 μs after 24 hours)
MECHANICAL
Chassis:
1U rack 19”
Width:
482 mm
Height:
43.6 mm
Depth:
460.5 mm without fans
Weight:
7.5 Kg
CONTROLS
TFT touchscreen
Web GUI
SNMP
GPIO
ENVIRONMENTAL
Operating Temperature Range:
-5°C ÷ 40°C
Max. relative Humidity:
90% non condensing
Max. operating altitude:
2500 m. a, s, l, (>2500 m. optional)
ELECTRICAL
Power Supply:
Single Phase 100÷240 V~ 50/60 Hz, IEC320 C14 Plug
Maximum consumption:
196 W @ 30 W rms (Onedriver 30U)
215 W @ 50 W rms (Onedriver 50U)
290 W @ 80 W rms (Onedriver 80HU)
470 W @ 130 W rms (Onedriver 130HU)
380 W @ 100 W rms (Onedriver 100V)
|
Reviews
There are no reviews yet.